Fujitsu 1FINITY L100 User Manual page 397

System Maintenance
Equipment Replacement
Caution: When tightening the two screws, alternate between them; do not overtighten either screw or
tighten one completely before tightening the other.
Warning: The attachment screws mentioned in this step must be lined up straight in the holes and should
easily turn, right up to the point of being tight. If any resistance occurs in the first turn, stop immediately, or
risk damage to the blade (broken screws and screw holes on the blade).
Figure 150
Attachment Screws
Step 28
Replace the protection cover on the power terminal adapter.
Figure 151
Attaching Protection Cover
·
Release 19.1.1 Issue 1.1, May 2021
397
Fujitsu and Fujitsu Customer Use Only