Fujitsu 1FINITY L100 User Manual page 142

Equipment Installation
Install Power Cables
Figure 73
Removing Protection Cover
Step 2
Attach the power cables to the power terminal adapter by performing the following substeps:
Warning: Make sure to use terminating cable lugs bent at 90 degrees if stacking multiple blades in a rack.
The cables make contact below the power terminal adapter if the lugs are not bent at 90 degrees.
Figure 74
Installing Power Cables
a) Attach the frame ground cable (green/yellow) to the terminal marked FG on the power terminal adapter.
b) Attach the ground cable (black) for the A power feed to the terminal marked GA on the power terminal
adapter.
c) Attach the power feed A cable (red) to the terminal marked MAIN A on the power terminal adapter.
·
Release 19.1.1 Issue 1.1, May 2021
Protection Cover
142
Fujitsu and Fujitsu Customer Use Only