Provision Proxy-Arp - Fujitsu 1FINITY L100 User Manual

System Administration

Provision Proxy-ARP

6.11
Provision Proxy-ARP
Prerequisite:
■ The user must be logged on as fujitsu/1finity or have Level-4 privileges assigned to perform this procedure.
This procedure describes how to provision Proxy-ARP for the L100 Blade.
Note: The network management system accesses the RNE through a DCN router that in turn interfaces with a
GNE on which an embedded communication channel, for example, OSC, with an IP subnet and has been
configured. This GNE has an OSPF or static route provisioned on its OSC port, and has Proxy-ARP provisioned on
the specific interfaces used to communicate with the DCN router, thus, enabling the network management
system to connect to the RNE.
Note: The user can run OSPF on the embedded side or can provision static routes.
Step 1
Enter configuration mode, if necessary.
Command:
> configure
Step 2
Is the LCN1 port provisioned?
If YES:
Proceed to Step 4.
If NO:
Continue with next step.
Step 3
Enable Ethernet and line rate on the LCN1 port.
Command:
% set interface interfaces eth-1/0/0/LCN1 type ethernetCsmacd enabled ethernet
speed 100 admin-status up
Note: By default, Ethernet interface and IP interface are autoprovisioned.
Step 4
Set IP address on the LCN1 interface.
Command:
% set interfaces interface <interface name> type <type> ip ipv4 <enabled/disabled>
forwarding <true/false> address <ip_address> netmask <netmask address>
·
Release 19.1.1 Issue 1.1, May 2021
235
Fujitsu and Fujitsu Customer Use Only