Install Cd Roadm Cabling - Fujitsu 1FINITY L100 User Manual

156
Equipment Installation

Install CD ROADM Cabling

4.19
Install CD ROADM Cabling
Note: For each step in this procedure, verify that the dust cover has been removed from both the port and the
fiber-optic cable. Verify that both the port and the fiber-optic cable connectors are free of dust and other
contaminants before connecting the fiber-optic cable.
Step 1
Connect the fiber-optic cables from the transponder and/or the muxponder units to the appropriate client port
(C1...C16) on a 4x16 splitter/coupler PIU.
Step 2
For add/drop connections, connect the fiber-optic cables from the appropriate edge ports (E1...E4) on a 4x16
splitter/coupler PIU to the appropriate client port (C1...C9) on the 1x9 WSS ROB.
Step 3
For pass-through (hub) connections, connect the fiber-optic cables to the appropriate client ports (C1...C9) on
the 1x9 WSS ROB between the ROADM degrees.
✓
This task is complete.
· Fujitsu and Fujitsu Customer Use Only
Release 19.1.1 Issue 1.1, May 2021