Table of Contents
Advertisement
257
ROADM Turn-Up and Operations
Provision L100 Main Blade OTS/OMS/OCH Interfaces
7.4
Provision L100 Main Blade OTS/OMS/OCH Interfaces
Step 1
Enable the Optical Transmission Section (OTS) for the Main L100 Blade.
Command:
% set interfaces interface ots-1/0/0/E1 type opticalTransport ots degree-number 1
operation-mode ope-mode-full-spec admin-status up
Step 2
Provision the Optical Multiplex Section (OMS) and postoutadj value for the Main L100 Blade.
Command:
% set interfaces interface ots-1/0/0/E1 ots oms admin-status up postoutadj <value>
Note: The postoutadj design value for the network is calculated during network design and planning process.
Postoutadj value range is within –15.0...0.0 dB. The default value is 0.0 dB. Setting should be implemented in
initial system turn-up.
Contact Fujitsu Support Center for assistance on the postoutadj value.
Step 3
Enable the OTS for a tributary L100 Blade.
Command:
% set interfaces interface ots-2/0/0/E1 type opticalTransport
ots degree-number 2
operation-mode ope-mode-full-spec admin-status up
Note: Repeat this step to enable the OTS for each tributary L100 Blade.
Step 4
Provision the OMS and a postoutadj value for a tributary L100 Blade.
Command:
% set interfaces interface ots-2/0/0/E1 ots oms admin-status up postoutadj <value>
Note: Repeat this step to enable the OMS for each tributary L100 Blade.
Step 5
Provision an OCH interface.
Command:
% set interfaces interface ots-2/0/0/E1 ots oms och 1 admin-status up center-
frequency 196.1
Note: Repeat this step for each OCH interface to be provisioned.
Note: With flexible grid enabled, the slot width can be provisioned for a value between 37.5 to 100 GHz (in 12.5
GHz increments) with a maximum of 128 channels.
·
Fujitsu and Fujitsu Customer Use Only
Release 19.1.1
Issue 1.1, May 2021
Advertisement
Table of Contents
