Fujitsu 1FINITY L100 User Manual page 385

System Maintenance
Equipment Replacement
Step 34
Did the Main blade had a USB flash drive that was removed in
If YES:
Continue with next step.
If NO:
Proceed to Step 38.
Step 35
Insert USB flash drive in the replacement Main blade.
Step 36
Turn the power on at the source and wait for the blade to initialize.
Warning: After the blade is powered up, power down within 15 minutes causes database corruption,
which leads to blade start-up failure and requires a return to factory for reprogramming.
Step 37
Verify that previous OSL and provisioning are restored to Main blade.
Step Result:
Procedure is complete.
Step 38
Is a database backup available for the blade being replaced?
If YES:
Proceed to Restore Configuration Database
If NO:
Proceed to Equipment Installation
Step 39
Turn the power on at the source and wait for the blade to initialize.
Step 40
Provision the tributary blade equipment.
Command:
> request set-shelfmode shelfid <x> shelfrole TRIB
Step Result:
Procedure is complete.
✓
This task is complete.
·
Release 19.1.1 Issue 1.1, May 2021
Step
and continue with next step.
and continue with next step.
1?
Fujitsu and Fujitsu Customer Use Only
385