Fujitsu 1FINITY L100 User Manual page 147

147
Equipment Installation
Install Fan Unit
Electrostatic Discharge (ESD)
Wrist Strap Grounding Post
INPUT RATING:
-48V ---.
20A MAX.
FUSED AT 25A
Maintenance Ports FAN LEDs
(Factory use only: do not use.)
Figure 79
FAN LEDs
Step Result:
When the Fan unit is inserted, the fans should start running and the FAN LEDs on rear-left side of the blade lights
green. The Fan unit has two or three FAN LEDs, depending on the blade type.
Note: The FAN LEDs change to green if power is applied to the blade.
✓
This task is complete.
Additional Instructions:
Perform the same procedure, as needed, to insert additional Fan units into the remaining Fan unit slots.
· Fujitsu and Fujitsu Customer Use Only
Release 19.1.1 Issue 1.1, May 2021