Fujitsu 1FINITY L100 User Manual page 194

194
Initial System Turn Up
Provision L100 Tributary Blade and Ports
Note: If a user provisions any UTLP equipment and UTLP interface in an earlier release, use the following
commands.
Commands:
% delete interfaces interface eth-2/0/0/UTLP
% delete eqpt shelf 2 slot 0 subslot 0 port UTLP
% set eqpt shelf 2 slot 0 subslot 0 port UTLP pluggableInterfaceType Fixed
Step 10
Provision the UTLP port interface.
Command:
% set interfaces interface eth-2/0/0/UTLP type ethernetCsmacd ethernet duplex full
speed 1000 mtu 1522 auto-negotiation enabled admin-status up
✓
This task is complete.
· Fujitsu and Fujitsu Customer Use Only
Release 19.1.1 Issue 1.1, May 2021