Ztp-Boot; Zeroize System - Fujitsu 1FINITY L100 User Manual

219
System Administration
System Feature Administration
Note: For more detailed ZTP information, refer to 1FINITY ZTP User Guide, available on the Fujitsu Partners
website, https://partners.fnc.fujitsu.com/documentation.
Show ZTP Configuration
Command:
> show system ztp
Output Example:
ztp-enabled true;
[ok]
Enable/Disable ZTP
Command:
% set system ztp ztp-enabled <false|true>
Show ZTP Operational Data
Command:
> show system ztp ztp-oper-data
Output Example:
system ztp ztp-oper-data controller-reg-status not-registered
system ztp ztp-oper-data controller-ip-addr 0.0.0.0
[ok]
6.6.6

ZTP-Boot

ZTP-Boot is provisioned by default on L100 Blade.
Both system ztp auto-upgrade and system ztp ztp-enabled flags control the enabling and disabling of ZTP-Boot.
The ztp-enabled flag controls the enabling and disabling of ZTP-announcement. If either flag is set to false, ZTP-
Boot is disabled. By default, both flags are enabled.
After device turn-up, if auto-upgrade or ztp-enabled is false, the auto-upgrade process is not started.
Enable/Disable ZTP-Boot
Command:
% set system ztp ztp-enabled <false|true> auto-upgrade <false|true>
6.6.7

Zeroize System

· Fujitsu and Fujitsu Customer Use Only
Release 19.1.1 Issue 1.1, May 2021