Table of Contents
Advertisement
System Maintenance
Backup and Restore
Restore Secondary Database from USB Flash Drive
This procedure describes how to use CLI commands in a L100 CLI window to restore the secondary database
through the USB flash drive in a new or used L100 Blade. The procedure applies to the Main L100 Blade only. The
tributary blades do not have database and are provisioned through the Main L100 Blade.
Note: The user must be logged on as fujitsu or have Level-4 or Level-5 privileges assigned to perform this
procedure.
Step 1
Is a faulty blade being replaced?
If YES:
Continue with next step.
If NO:
Proceed to
Step
5.
Step 2
Power down the faulty L100 Blade.
Step 3
Remove the USB flash drive with the secondary database from the faulty L100 Blade.
Step 4
Uninstall the faulty L100 Blade from the rack. Refer to
Step 5
Install the replacement L100 Blade, but do not power it up. Refer to
Note: To restore the secondary database on USB flash drive to the replacement blade, the replacement blade
must be in shelf provisioning mode. If replacing a faulty blade with a previously used L100 Blade, place the blade
into shelf provisioning mode before inserting the USB flash drive.
Step 6
Is the replacement blade a new L100 Blade from the factory that is already in shelf provisioning mode?
If YES:
Proceed to
Step
12.
If NO:
Continue with next step.
Step 7
Power up the replacement L100 Blade.
·
Release 19.1.1
Issue 1.1, May 2021
Remove Blade from Rack
for more information.
Initial System Turn Up
420
for more information.
Fujitsu and Fujitsu Customer Use Only
Advertisement
Table of Contents
