Connect Lcn1 To Dcn - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN
Step 5
Configure the next hop. This step creates the routing instance if it does not already exist.
Command:
% set routing routing-instance <routing_instance_name> routing-protocols routing-
protocol static <protocol_instance_name> static-routes ipv4 route 0.0.0.0/0 next-
hop next-hop-address <ip_address>
Parameter
routing_instance_name
protocol_instance_name
ip_address
Command Example:
% set routing routing-instance MCN routing-protocols
routing-protocol static FNC static-routes ipv4 route 0.0.0.0/0
next-hop next-hop-address 192.168.229.254
Step 6
Check the candidate configuration, if desired.
Command:
% show routing routing-instance
Step 7
Save the changes.
Command:
% commit
Step 8
Exit configuration mode.
Command:
% exit

Connect LCN1 to DCN

Step 9
Connect the LCN1 port to the DCN.
✓
This task is complete.
·
Release 19.1.1 Issue 1.1, May 2021
Value
<MCN>
<FNC>
<1xx.xxx.xxx.xxx>
Description
Name of routing instance
Name of protocol instance
IP address of next hop
Fujitsu and Fujitsu Customer Use Only
172