Set Static Ip Address On Lcn1; Configure Next-Hop - Fujitsu 1FINITY L100 User Manual

Initial System Turn Up
Configure IP Connection to DCN
Note: The NE that is being turned up connects to the end of the daisy chain. The other NEs must be configured
to bridge traffic between LCN1 and LCN2 (set
Step 1
Change to CLI configuration mode.
Command:
> configure

Set Static IP Address on LCN1

Step 2
Disable DHCP on LCN1 interface.
Command:
% set clientv4 client-if ip-1/0/0/LCN1 enable false
Step 3
Set IP address on the LCN1 interface.
Command:
% set interfaces interface ip-1/0/0/LCN1 type ip ipv4 enabled forwarding true
address <ip_address> prefix-length <prefix-length>
Parameter
ip_address
prefix-length
Command Example:
% set interfaces interface ip-1/0/0/LCN1 type ip ipv4
enabled forwarding true address 192.168.229.64 prefix-length 24
Step 4
Check the candidate configuration, if desired.
Command:
% show interfaces interface ip-1/0/0/LCN1

Configure Next-Hop

If the NE connects directly to the DCN, the next hop should be the address of the default router. Otherwise, the
next hop should be the IP address of the neighboring NE that is closer to the DCN in the chain of GCC0-linked
NEs.
·
Release 19.1.1 Issue 1.1, May 2021
neMgmtMode to Bridge or MixMode).
Value
<1xx.xxx.xxx.xxx>
<0...32>
Description
IP address of the LCN interface
Length of the subnet prefix
Fujitsu and Fujitsu Customer Use Only
171