System Feature Administration; Autop; Rasis - Fujitsu 1FINITY L100 User Manual

System Administration

System Feature Administration

6.6

System Feature Administration

In this section:
6.6.1

AutoP

6.6.2

RASIS

6.6.3 neMgmtMode
6.6.4 Telemetry, Streaming
6.6.1
AutoP
Show AutoP Configuration
Command:
% show system autoP
Enable/Disable Autoprovisioning
Autoprovisioning is enabled by factory default.
Command:
% set system autoP <true|false>
6.6.2
RASIS
Note: For more detailed RASIS information, refer to 1FINITY RASIS User Guide, available on the Fujitsu Partners
website, https://partners.fnc.fujitsu.com/documentation.
Provision to trigger-tech-info On-Demand Logging
Note: For L-series blades, on-demand logging supports MicroBlade Log (MBLOG) and Firmware Log (FWLOG).
Trigger-tech-info uses the CLI command to write log messages to the hardware.
Command Examples:
> request trigger-tech-info shelf-id <shelf num> trigger <log type>
> request trigger-tech-info shelf-id 1 trigger MBLOG
[ok]
> request trigger-tech-info shelf-id 1 trigger FWLOG
[ok]
An alarm raises when a specific log (MBLOG, FWLOG) write is in progress. When write is completed, the alarm
clears.
·
Release 19.1.1 Issue 1.1, May 2021
6.6.5 ZTP
6.6.6 ZTP-Boot
6.6.7 Zeroize System
6.6.8 Configure AINS
216
Fujitsu and Fujitsu Customer Use Only