Cli Configuration Mode - Fujitsu 1FINITY L100 User Manual

System Administration
About CLI
Command
file
ftp
help
id
monitor
quit
request
set
set-path
sftp
show
ssh
ssh-key-remove
start
telnet
top
up
6.2.2

CLI Configuration Mode

To change CLI Session from operational mode to configuration mode, enter the configure command.
Command:
> configure
When the CLI session is in the configuration mode, the command prompt terminates with the "%" character.
Command Example:
fujitsu@fujitsu%
In configuration mode, all changes to the device configuration are initially done to a copy of the active
configuration called the candidate configuration. These changes do not take effect until a successful commit or
commit confirm command is entered. Commit activates the candidate configuration on the device. Candidate
configurations enable the user to alter the configuration without causing potential damage to the current
network operations.
·
Release 19.1.1 Issue 1.1, May 2021
Description
Perform file operations
Open a ftp session to another host
Provide help information
Show user id information
Show real-time debugging information
Exit the management session
Make system-level requests
Set CLI properties
Set relative show path
Open a sftp session to another host
Show information about the system
Start a secure shell to another host
Remove host from know hosts file
Start specified program or command
Establish a Telnet session to another host
Exit to top level and optionally run command
Exit one level of configuration
205
Fujitsu and Fujitsu Customer Use Only