Default-Metric (Ipv6 Ospf) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

default-metric (IPv6 OSPF)

default-metric METRIC-VALUE
no default-metric [METRIC-VALUE]
Syntax Description
METRIC-VALUE
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # router ipv6 ospf
Switch (config-router) # default-metric 10
Switch (config-router) # redistribute rip
CLI Reference Guide
To set the default metric for IPv6 OSPF, use the default-mertic command. To
return the metric to its default value, use the no form of this command.
Default metric value. A number from 1 to 16777214.
METRIC-VALUE: 20
Router configuration
The default-metric command is used in conjunction with the redistribute router
configuration command (redistribute (IPv6 OSPF) command on page 505) to
cause the current routing protocol to use the same metric value for all
redistributed routes. A default metric helps solve the problem of redistributing
routes with an incompatible metric. Whenever metrics do not convert, using a
default metric provides a reasonable substitute and enables the redistribution to
proceed.
The order of the setting precedence to determine the metric is:
set metric in redistributed command > default-metric setting.
The following example shows an IPv6 OSPF redistributing routes from RIP. All
redistributed routes are advertised with a metric of 10.
default-metric (IPv6 OSPF)
143