D-Link DGS-6600-48T Cli Reference Manual page 681

DGS-6604 m
Field
Routing Protocol is
"rip"
Sending updates
every 30 seconds
next due in 2 seconds Precisely when the next update is due to be sent.
Invalid after 180
seconds
garbage collect after
120
Default version
control:
Redistributing
Routing
Routing Information
Sources
Switch# show ip protocols ospf
Routing Protocol is "ospf"
Configured Router ID: 10.253.41.2
Redistribute route default metric:auto
Auto-cost Reference-bandwidth:100
Distance: (default is 110)
Do not originate type 5 default route
Redistributing:
type
---------------------------------------
rip
Switch#
CLI Reference Guide
The table below describes the show ip protocols Field Descriptions for a RIP
Process:
Description
Specifies the routing protocol used.
Specifies the time between sending updates.
Specifies the value of the invalid parameter.
Specifies the time (in seconds) after which the individual routing information will
be thrown (flushed) out.
Specifies the version of RIP packets that are sent and received.
Lists the protocol that is being redistributed.
Specifies the networks for which the routing process is currently injecting routes.
Lists all the routing sources the operating system software is using to build its
routing table. For each source, the following will be displayed:
• IP address
• Administrative distance
• Time the last update was received from this source
The following example shows how to output the state of OSPF protocol:
metric mtric_type
20 2
show ip protocols
671