Logging On - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

logging on

logging on
no logging on
Syntax
Default
Command Mode
Usage Guideline
Example
Switch> enable
switch# configure terminal
Switch(config)# logging on
CLI Reference Guide
Use the logging on command to start logging system messages on this switch.
Use the no form of this command to stop logging.
None
Logging of system messages is on.
Global configuration
To enable logging of system messages, use the logging on command in global
configuration mode.
To set logging of system messages to on, execute the below commands.
Verify the settings with the show logging command.
logging on
391