Show Ip Mroute - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip mroute

show ip mroute [ { [group-addr GROUP-ADDRESS ] [source-addr NETWORK-ADDRESS ]
[summary] } |static]
Syntax Description
group-addr
GROUP-ADDRESS
source-addr
NETWORK-ADDRESS
summary
static
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use this command to display the content of the IP multicast routing table.
(Optional) Specifies the Group IP address.
(Optional) Specifies the Source IP network address.
(Optional) Displays a one-line, abbreviated summary of each entry in
the IP multicast routing table.
(Optional) Displays the multicast static routes
None
User EXEC or any configuration mode
Displays the content of the IP multicast table.
The "Uptime" timer describes the time elapsed since the entry was created.
The "Expires" timer is a keep-alive timer for the multicast data stream. The
Expires timer value is based on either the PIM Sparse and Dense Mode RFCs
(RFC 4601 and RFC 3973) or DVMRP. If the multicast data continues to arrive at
the device, the timer will renew itself.
If network address is specified, the switch displays the entries with source
addresses that match the specified address.
show ip mroute
635