Ip Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ip address

ip address { IP-ADDRESS SUBNET-MASK [ secondary ] | dhcp }
no ip address [ IP-ADDRESS SUBNET-MASK ]
Syntax Description
IP-ADDRESS
SUBNET-MASK
secondary
dhcp
Default
Command Mode
Usage Guideline
Example
CLI Reference Guide
Use ip address to set a primary or secondary IP address for an interface, or
acquire an IP address on an interface from DHCP. Use the no form of the
command to remove the IP settings configuration from the interface.
The IP address to configure the interface with.
The mask for the associated IP subnet of the IP address.
(Optional) Specifies that the configured address is a secondary IP address. If
this keyword is omitted, the configured address is the primary IP address.
Acquire an IP address on an interface from the DHCP protocol.
0.0.0.0/32.
VLAN Interface configuration
Only VLAN interfaces are valid for this command.
An interface can have one primary IP address and multiple secondary IP
addresses. IP processing can be disabled on a particular interface by removing
its IP address with the no ip address command. If the software detects another
host using one of its IP addresses, an error message appears on the console.
The optional secondary keyword allows assignment of multiple secondary
addresses. Secondary addresses are treated like the primary address, except
that the system does not generate datagrams other than a routing update packet
with secondary source addresses. For example, an SNMP trap is always
generated with the primary address. However, the system can respond to a
packet sent to the secondary address.
For now, only VLAN interfaces can be configured by this command.
If a VLAN interface has been configured with static IP address (except 0.0.0.0) or
DHCP, a Layer 3 IP interface is created.
The no ip address command will remove all of the IP settings from the interface.
This example (on the next page) shows how to set 10.108.1.27 as the primary
address and 192.31.7.17 and 192.31.8.17 as the secondary addresses for VLAN
100:
ip address
216