Subnet-Mask - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

subnet-mask

subnet-mask MASK
no subnet-mask
Syntax Description
MASK
Default
Command Mode
Usage Guideline
Examples
switch#configure terminal
switch(config)#ip dhcp pool pool1
switch(config-dhcp)#subnet-mask 255.0.0.0
switch(config-dhcp)#
CLI Reference Guide
Use this command to configure the subnet mask for a DHCP address pool of the
DHCP Server. Use the no form of this command to restore the configuration of a
subnet mask to the default mask 255.255.255.0.
The bit combination of the addresses, in the DHCP address pool, determines
which part of the address refers to the network or subnet and which part refers to
the host. It is in the format of xxx.xxx.xxx.xxx in which xxx is the number range
from 0 to 255 where all of its binary bits must be continuous.
MASK: 255.255.255.0
DHCP pool configuration
This command configures the subnet mask that the DHCP server is uses to
assign to DHCP clients. It is valid for the associated DHCP address pools only.
The following is an example of configuring 255.0.0.0 as the DHCP pool's subnet
mask .
subnet-mask
867