Based-On Mac-Address - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

based-on mac-address

based-on mac-address MAC-ADDRESS [,|-]
no based-on mac-address MAC-ADDRESS [,|-]
Syntax Description
MAC-ADDRESS [,|-]
Default
Command Mode
Usage Guideline
Examples
switch(config)#ip dhcp pool pool1
switch(config-dhcp)#based-on mac-address 00:80:C8:11:22:00-00:80:C8:11:22:FF
switch(config-dhcp)#based-on mac-address 00:80:C8:11:33:00,00:80:C8:11:33:FF
CLI Reference Guide
This command is used to specify the host MAC address as a rule for IP address
assignment from the DHCP address pool. Use the no form to remove the MAC
address rule from the DHCP address pool.
Specifies the MAC address list.
None
DHCP pool configuration
This command is used to create the address binding rule for the DHCP address
pool. based-on mac-address command creates the address binding rules in an
incremental way. That is, all of the mac-addresses created by the based-on mac-
address commands take effect on the corresponding DHCP address pool.
However this command will be combined using logical AND operations with the
other rules is set by all other based-on commands. For example if the first rule is
based-on mac-address 00:80:00:11:22:00- 00:80:00:11:22:FF and there is
another based-on c-vid 200 command, the address pool will only assign an IP
address to the client with a MAC address in range of 00:80:11:22:xx and with its
C-VID=200. Other than that, no IP address is offered from the corresponding
DHCP address pool.
The following sets a rule used for IP address assignment based on MAC address
00:80:C8:11:22:xx from the DHCP address pool1.
The following sets an additional rule used for IP address assignment based on
MAC address 00:80:C8:11:33:00 and 00:80:C8:11:33:FF from the DHCP
address pool1.
based-on mac-address
62