Vlan-Tunnel Remove-Inner-Tag - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vlan-tunnel remove-inner-tag

vlan-tunnel remove-inner-tag
no vlan-tunnel remove-inner-tag
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config)#interface eth3.1
Switch(config-if)#vlan-tunnel remove-inner-tag
CLI Reference Guide
Use this command to strip off the packet's inner tag (C-TAG; should the packet
have it) of the incoming packet. Use the no form of the command to keep the
packet's inner tag.
None
Disabled
Interface configuration (only available for UNI ports only).
The command is available only for a UNI port. If an incoming packet has an inner
tag (C-TAG) and the packet is forwarded to a UNI port which is configured as
remove-inner-tag enabled, then the packet's inner tag is removed.
This example shows how to enable the vlan-tunnel remove-inner-tag in
Ethernet eth3.1
Verify the settings by entering show vlan-tunnel command.
vlan-tunnel remove-inner-tag
909