DGS-6604
m
Example
Switch(config)# interface range
Switch(config-if)# channel-group 3 mode active
CLI Reference Guide
• In order to be a member of the LACP channel-group, the member ports
must have the same speed setting. LACP will not prevent the user config-
uration if these ports have difference speed setting in the same channel
group. LACP protocol behavior will choose the members that have the
same speed to for the link aggregation.
This example shows how to configure a channel group. It assigns the eth3.4 to
3.5 to port-channel 3 with the LACP mode active.
Verify the settings by entering the show channel-group command
eth3.4-3.5
channel-group
85