Police Cir - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

police cir

police cir CIR [bc CONFORM-BURST] pir PIR [be PEAK-BURST] [exceed-action ACTION
[violate-action ACTION]]
no police cir CIR [bc CONFORM-BURST] pir PIR [be PEAK-BURST] [exceed-action ACTION
[violate-action ACTION]]
Syntax Description
CIR
PIR
CONFORM-BURST
PEAK-BURST
exceed-action
violate-action
ACTION
Default
CLI Reference Guide
To configure traffic policing using two rates, the committed information rate (CIR)
and the peak information rate (PIR), use the police cir command in policy-map
class configuration mode. To remove two-rate traffic policing from the
configuration, use the no form of this command
Specifies the committed information rate in bits per second. The committed
packet rate is the first token bucket for the two-rate metering.
min: 64KB max:32GB
Specifies the peak information rate in bits per second. The peak information rate
is the second token bucket for the two-rate metering.
min: 64KB max:32GB
Specifies the burst size for the first token bucket in bytes.
Valid values are project dependent.
min:4KB max:16MB default:4KB
Specifies the burst size for the second token bucket in bytes.
Valid values are project dependent.
min:4KB max:16MB default:4KB
(Optional) Specifies the action to take for those packets that conform to PIR but
not to CIR. It is referred as yellow color traffic.
(Optional) Specifies the action to take for those packets that did not conform to
both CIR and PIR. It is referred as red color traffic.
The actions can be
drop - Packets will be dropped.
set-dscp-transmit VALUE - Sets the IP differentiated services code point
(DSCP) value and transmits the packet with the new IP DSCP value.
transmit - Transmits the packet. The packet is not altered.
Disabled
exceed-action: drop
police cir
478