DGS-6604
ipv6 neighbor
ipv6 neighbor X:X::X:X IFNAME MAC
no ipv6 neighbor X:X::X:X IFNAME
Syntax Description
X:X::X:X
IFNAME
MAC
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config) # ipv6 neighbor fe80::1 vlan1 00-01-80-11-22-99
Switch (config) #
CLI Reference Guide
This command is used to add a static ipv6 neighbor entry. The no form of this
command deletes the IPv6 neighbor entry.
IPv6 address. This argument must be in the form documented by RFC2373
where the address is specified in hexadecimal using a 16-bit value between
colons.
XXXX: IPv6 address
The IP Interface name
The MAC address, in XX-XX-XX-XX-XX-XX format
None
Global configuration.
None
This example shows how to configure an IPv6 neighbor entry:
ipv6 neighbor
340