Dot1X Timeout - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

dot1x timeout

dot1x timeout {quiet-period SECONDS | reauth-period SECONDS | server-timeout SECONDS
| supp-timeout SECONDS | tx-period SECONDS }
Syntax Description
quiet-period
SECONDS
reauth-period
SECONDS
server-timeout
SECONDS
supp-timeout
SECONDS
tx-period SECONDS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x timeout quiet-period 20
Switch(config-if)# dot1x timeout reauth-period 1000
Switch(config-if)# dot1x timeout server-timeout 15
Switch(config-if)# dot1x timeout supp-timeout 15
Switch(config-if)# dot1x timeout tx-period 10
CLI Reference Guide
Use this command to set timeout values for various 802.1X timers.
Number of seconds that the switch remains in the quiet state following a failed
authentication exchange with the client. The range is 0 to 65535.
Number of seconds between re-authentication attempts. The range is 1 to 65535
Number of seconds that the switch will wait when it does not receive notification
from the authentication server. The range is 1 to 65535.
Number of seconds that the switch will wait when it does not receive any
notification from the client. The range is 1 to 65535.
Number of seconds that the switch waits for a response to an EAP-request/
identity frame from the client before retransmitting the request. The range is 1 to
65535.
quiet-period: 60 seconds
reauth-period:3600 seconds
server-timeou: 30 seconds
supp-timeout: 30 seconds
tx-period: 30 seconds
Interface configuration
This command is only valid for physical port interface.
The reauth-period takes effect when re-authentication is configured by the
dot1x re-authentication command on page 172.
This example sets quiet-period, reauth-period, server-timeout, supp-timeout,
and tx-period on eth4.1 to be 20, 1000, 15, 15, and 10 seconds, respectively.
Verify the settings by entering the show dot1x auth-configuration command.
dot1x timeout
174