Show Access-Group - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show access-group

show access-group [ interface INTERFACE-ID ] [ ip [ NAME ] | mac [ NAME ] | ipv6 [ NAME ]]
Syntax Description
interface
INTERFACE-ID
ip
mac
ipv6
NAME
Default
Command Mode
Usage Guideline
Example
Switch# show access-group
eth3.1
Inbound mac access-list : simple-mac-acl
Inbound ip access-list
Inbound ipv6 access-list : ip6-control
eth3.2
Inbound mac access-list : rd-mac-acl
Inbound ip access-list
Inbound ipv6 access-list : N/A
CLI Reference Guide
Use this command to display how the mac, ip and ipv6 access-lists are applied to
interfaces.
(Optional) Specifies the interface to be displayed. If not specified, the access-
groups for all interfaces will be displayed.
(Optional) Specifies that only the ip access group on the specified interface(s)
will be displayed.
(Optional) Specifies that only the mac access group on the specified interface(s)
will be displayed.
Optional) Specifies that only the ipv6 access group on the specified interface(s)
will be displayed.
(Optional) The name of the access-list (mac, ip, ipv6) to be displayed.
None
User EXEC or any configuration mode
Since there is both an ip extended access-list and an ip access-list, use the
access-list NAME to distinguish them.
This example shows how the IP access-list is applied to all of the interfaces.
: simple-ip-acl
: rd-ip-acl
show access-group
561