Qos Map Dscp-Cos - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

qos map dscp-cos

qos map dscp-cos DSCP-LIST to COS-VALUE
no qos map dscp-cos
Syntax Description
dscp-cos DSCP-LIST
to COST-VALUE
Default
Command Mode
Usage Guideline
Example
Switch(config)# interface eth2.6
Switch(config-if)# qos map dscp-cos 12,16,18 to 1
Switch(config-if)#end
CLI Reference Guide
To define a differentiated services code point (DSCP)-to-class of service (CoS)
map, use the qos map dscp-cos command in global configuration mode. To
remove a prior entry, use the no form of this command.
Specifies the list of DSCP code point to be mapped to a COS value. The range
of DSCP is 0 to 63. The series of DSCPs can be separated by comma (,) or
hyphen(-). No space is before and after , or -. The COS-VALUE range is 0 ~ 7
Below is a table of the default dscp-cos mappings:
DSCP ValueCOS Value
0-7
8-15
16-23
24-31
32-39
40-47
48-55
56-63
Interface Configuration
The DSCP to CoS map is used by the DSCP trust port to map the DSCP value to
an internal CoS value, which will be in turn be mapped to the CoS queue based
on the CoS to queue map configured by the qos map cos command.
Only physical ports are valid for this command. All of the DSCP-to-CoS maps are
globally defined. The map applies to all ports.
This example configures the DSCP to CoS map for mapping DSCP 12, 16, 18 to
CoS 1 for eth2.6.
Use the show qos interface map privileged EXEC command to verify the
settings.
0
1
2
3
4
5
6
7
qos map dscp-cos
498