Reboot - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

reboot

R
reboot [unit UNIT-ID ]
Syntax Description
UNIT-ID
Default
Command Mode.
Usage Guideline
Example
DGS-6600:15#reboot
Warning: This command will cause system reboot.
Do you want to continue (y/n) [n]?y
Save log message before reboot(y/n) [n]?y
CLI Reference Guide
Use this command to reboot a module on the specified slot. The module can be
either a control module or a line card control module.
Specifies the unit id.
None
Privileged EXEC level 15
This command is only available for privilege level 15 and above.
This command can be used to reboot a module in a specific slot. If no unit ID is
specified, all of the modules in the system will be rebooted.
If the CM module is specified to be reboot, then the entire system (all modules)
will reboot.
Note:
The following example reboots the whole system:
reboot
501