D-Link DGS-6600-48T Cli Reference Manual page 399

DGS-6604 m
Command Mode
Usage Guideline
Example
Switch> enable
Switch# configure terminal
Switch(config)# logging host
CLI Reference Guide
facility: local7
Global configuration
The number of supporting SYSLOG servers is project dependent. When the
number of configured SYSLOG servers reaches the maximum capacity, a new
SYSLOG server is unable to be configured before and existing entry is deleted
using the command no logging host.
The severity level limits the logging of system messages sent to Syslog servers
to only those messages at and up to the specified level. For example, if the
severity is debugging, all logs in the Syslog daemon are sent to the log server
host. If the level of log is alert, then only alert and emergency logs are sent.
The keyword facility specifies the syslog facility in the SYSLOG messages which
are sent to the server.
For the no command, if the IP address is not specified, all logging hosts will be
deleted.
The below example shows how to create a log server with the host address
20.3.3.3 . The command configures the server to receive logs with a severity
level set to critical
20.3.3.3 severity critical
Verify the settings with the show logging host command.
logging host
389