DGS-6604
m
Examples
Switch# configure terminal
Switch(config)# monitor session 1 destination interface eth3.1
Switch(config)# monitor session 1 source interface eth3.2-3.4
Switch(config)# end
Switch# configure terminal
Switch(config)# no monitor session 1 source interface eth3.2,eth3.4
Switch(config)# end
CLI Reference Guide
• IEEE 802.1x authentication on a port cannot be enabled for a destination
port, but is allowed on the source port.
Entering no monitor session without specifying a session number deletes all
port mirroring sessions.
This example shows how to create a port mirroring session with session number
1. It assigns a physical port (eth3.1) as a destination port and three source
physical ports (eth3.2, eth3.3, and eth3.4) as mirrored ports.
This example shows how to remove two source ports from a created port
mirroring session with session number 1.
Verify the settings by entering the show monitor session command.
monitor session
417