D-Link DGS-6600-48T Cli Reference Manual page 366

DGS-6604
Examples
Switch > enable
Switch # configure terminal
Switch (config) # ipv6 route 2001:0DB8::/32 vlan 1 fe80::0200:00ff:fe00:a0a0
distance 11
Switch (config) # ipv6 route 2001:0DB8::/32 vlan 2 fe80::0200:00ff:fe00:b0b0
distance 22
Switch > enable
Switch # configure terminal
Switch (config) # no ipv6 route 2001:0DB8::/32 vlan 1
fe80::0200:00ff:fe00:a0a0
CLI Reference Guide
• RIP 120
• RIPNG 120
• OSPF 110
• OSPF6 110
• EBGP 20
• IBGP 200
• ISIS 115
Assume that a routing protocol originates the same route to the same destination
as an existing static route. However, an operator would like to select the
calculation of the best route to choose from the routing protocols first. To do that
the operator needs to change the priority of the static route, since the default
priority of static routes is usually higher than dynamic routes.
This example shows how to create floating static routes. The System will
ultimately choose the higher priority (with less distance value) route to be the
master route toward the same destination. In this case, the route with distance
11 will be chosen as the master route toward the destination 2001:0DB8::/32.
This example shows how to delete the previously configured static route.
ipv6 route
356