D-Link DGS-6600-48T Cli Reference Manual page 63

DGS-6604 m
arp
arp IP-ADDRESS HARDWARE-ADDRESS
no arp IP-ADDRESS HARDWARE-ADDRESS
Syntax Description
IP-ADDRESS
HARDWARE-
ADDRESS
Default
Command Mode
Usage Guideline
Example
Switch(config)# arp 10.31.7.19 0800.0900.1834
CLI Reference Guide
Use this command to add a static entry in the Address Resolution Protocol (ARP)
cache. Use the no arp command to remove a static entry in the ARP cache.
IP address in four-part dotted decimal format corresponding to the local data-link
address.
Local data-link Media Access (MAC) address (a 48-bit address).
No entries are entered in the ARP cache.
Global configuration
Use the arp command to assign static and permanent entries to the ARP cache
entries. The cache is used to store the IP addresses and the corresponding MAC
address so that the addresses will not have to be repeatedly resolved. Static and
permanent entries are used for devices that exchange data on a regular basis.
To remove all non-static entries from the ARP cache, use the clear arp-cache
command.
This example shows how to add static ARP entry for a typical Ethernet host:
Verify the settings by entering the show arp command.
arp
53