Dot1X Max-Req - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 mm

dot1x max-req

dot1x max-req TIMES
Syntax Description
max-req
TIMES
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x max-req 3
CLI Reference Guide
Use this command to set the maximum number of times that the switch sends
EAP-request/identity frames to the client before restarting the authentication
process.
Number of times that the switch retransmits an EAP frame to the client before
restarting the authentication process. The range is 1 to 10.
TIMES: 2
Interface configuration
This command is only valid for physical port interface.
This example shows how to set the maximum number of retransmit times on port
eth4.1 to be 3.
Verify the settings with the show dot1x auth-configuration command.
dot1x max-req
168