DGS-6604
m
lldp receive
lldp receive
no lldp receive
Syntax
Default
Command Mode
Usage Guideline
Example
Switch(config-if)# lldp receive
Switch(config-if)# no lldp receive
CLI Reference Guide
To enable a physical interface to receive LLDP message, use the lldp receive
command in Interface Configuration mode. Use the no form of this command to
disable receiving LLDP message.
This command has no arguments or keywords.
LLDP is enabled on all supported interfaces.
Interface Configuration mode
This command is used to enable a physical interface to receive LLDP mes-
sage. When LLDP is not running (when the command no lldp run is issued
on global configuration mode), the switch doesn't receive LLDP message.
This example shows how to enable a physical interface to receive LLDP
message.
This example shows how to disable a physical interface to receive LLDP
message.
lldp receive
379