Loopback-Detection Interval-Time - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

loopback-detection interval-time

loopback-detection interval-time SECONDS
no loopback-detection interval-time
Syntax
Interval-time
SECONDS
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# loopback-detection interval-time 20
Switch(config)#
CLI Reference Guide
Use the command to configure timer interval. Use no command to return the
default settings.
The time interval (in seconds) at which device transmits all the CTP (Configuration
Test Protocol) packets to detect the loop-back event.
Valid range is from 1 to 32767.
The default setting is 10 seconds.
Configuration mode
The timer interval of the device will transmit the CTP (Configuration Test
Protocol) packets periodically to detect a loop-back event. If the loopback
detection mode is port-based, LBD will per port send the CTP packets.
Oppositely, LBD will per port per VLAN send the CTP packets periodically on
VLAN base mode.
This example shows how to configure the time interval.
You can verify your settings by entering the show loopback-detection command.
loopback-detection interval-time
398