D-Link DGS-6600-48T Cli Reference Manual page 887

DGS-6604 m
Switch#telnet 2001:e10:5c00:2::101:253
Connecting to 2001:e10:5c00:2::101:253 ...
Connected to Telnet connecting ...
Escape character is 'Ctrl-_'.
Telnet connecting ...
Copyright (c) 2010 D-Link Corporation. All rights reserved.
Switch>
Supported commands are:
e -
If other key is pressed, the terminal will return to the original active
Telnet session.
continuing...
Switch>
Switch#telnet 2001:e10:5c00:2::101:253 3500
Connecting to 2001:e10:5c00:2::101:253 ...
Connected to Telnet connecting ...
Escape character is 'Ctrl-_'.
Telnet connecting ...
Copyright (c) 2010 D-Link Corporation. All rights reserved.
Switch>
CLI Reference Guide
The following example show how to telnet to the IPv6 address
2001:e10:5c00:2::101:253 using default port 23, then enter the escape sequence
: Ctrl-_ and press any other key returning to the telnet session.
Chassis-based High-Speed Switch
Command Line Interface
Firmware: 1.00.029
terminate the current Telnet session
The following example show how to telnet to the IPv6 address
2001:e10:5c00:2::101:253 with specific port 3500.
Chassis-based High-Speed Switch
Command Line Interface
Firmware: 1.00.029
telnet
877