Storm-Control (Interface) - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

storm-control (Interface)

storm-control {broadcast | multicast | unicast}
no storm-control {broadcast | multicast | unicast}
Syntax Description
broadcast
multicast
unicast
Default
Command Mode
Usage Guideline
Examples
Switch# configure terminal
Switch(config)# interface eth3.1
Switch(config-if)# storm-control broadcast
Switch(config-if)# show storm-control interface broadcast
Interface Storm Action Type Threshold
-------------------------------------------------------------
eth3.1 Broadcast Drop pps 131072
Switch# configure terminal
Switch(config)# interface eth3.1
Switch(config-if)# no storm-control broadcast
CLI Reference Guide
Use this command to configure the device to prevent storm attacks on a LAN.
There are three traffic types, broadcast, multicast, and unicast (DLF). Use the no
form of the command to disable the storm-control function.
Set Broadcast rate limiting
Set Multicast rate limiting
Set Unicast(DLF) rate limiting
Disabled (all storm types)
Interface configuration
Only physical port interfaces are valid for this command.
Enter the "storm-control" command to enable Storm Control for a specific traffic
type on the interface.
All packets are passed in default without storm control enabled. After enabling
traffic storm control, if the storm-control action is to drop, then packets exceeding
the level will be dropped. If the storm-control action is set to shutdown, then the
interface will be shutdown whenever the packets exceed the threshold.
This example shows how to enable Broadcast storm control on interface eth3.1.
This example shows how to disable Broadcast storm control. on interface eth3.1.
Verify the settings by entering the show storm-control interface command.
storm-control (Interface)
859