Vrrp Priority - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

vrrp priority

vrrp VRID priority PRIORITY
no vrrp VRID priority
Syntax Description
VRID
PRIORITY
Default
Command Mode
Usage Guideline
Examples
Switch(config)#interface vlan1
Switch(config-if)#vrrp 7 priority 200
CLI Reference Guide
To set the priority of the virtual router, use the vrrp priority command in VRRP
interface configuration mode.
To restore the default priority value of the virtual router, use the no form of this
command.
Specifies the virtual router identifier, which is the number that identifies the virtual
router fthat the priority is being configured for.
The virtual router identifier is configured with the command "vrrp ip" on
page 917.
Range is from 1 to 255.
Specifies the priority of the virtual router. Higher values equal higher priority.
Range is from 1 to 254
Priority: 100
Interface configuration
Use this command to control which router becomes the master router. This
command is ignored while the router is the virtual IP address owner.
The router with the highest priority will become the master, and other routers with
lower priority will then become the backups for the virtual router. Each router
should be configured with different priority values. If there is more than one router
accidently configured to have the same highest priority, then one of them will
become the master which depends on which one of them sends the
advertisement packet out first. If the advertisement packets are sent out at the
same time, the primary IP address (see Note 1) will be compared. The router
with greater primary IP address becomes the master.
Note 1: the primary IP address is the interface IP address that is configured by
the command "ip address" on page 216.
The following example shows how to configure the router with a priority of 200.
vrrp priority
920