DGS-6604
m
Example
Switch(config)# interface eth3.24
Switch(config-if)# speed 100
Switch(config-if)# duplex auto
CLI Reference Guide
capability will consist of both the full and half duplex mode combined with the
configured speeds.
Before adding ports to a Port-Channel, verify that all settings are the same on
these ports. Otherwise the ports in a Port-Channel with different settings will
operate in an indeterminate manner.
In IEEE 802.3 (Clause 40) 1000BASE-T standard, Auto-Negotiation is defined as
necessary. Although we still provide a command to disable auto-negotiation for
1000BASE-T, setting it to enabled is recommended to prevent an unexpected
link status.
This example shows how to configure interface eth3.24 to force the settings to a
speed of 100Mbits and auto-negotiate to the duplex mode:
Verify the settings by entering the show interface command.
speed
858