Show Ip Verify Source - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show ip verify source

show ip verify source [interface INTERFACE-ID [, | -]]
Syntax
INTERFACE-ID
,
-
Default
Command Mode
Usage Guideline
Example
Switch# show ip verify source interface eth3.3
Interface Filter-type
--------- -----------
----
eth3.3 ip-mac
eth3.3 ip-mac
eth3.3 ip-mac
Total Entries: 3
Switch#
CLI Reference Guide
Use this command to display the port ACL entry on a particular interface.
Specifies a port or a range of ports to configure.
(Optional) Specify a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
(Optional) Specify a range of interfaces. No space before and after the hyphen.
Not applicable
EXEC mode or any configuration mode
Use the command to display the port ACL entries for a port.
This example shows the display when the interface has an IP source filter mode
that is configured as IP-MAC and an existing IP MAC binds 10.1.1.10 MAC
address 00-01-01-01-01-01 on VLAN 100 and 10.1.1.11 MAC address 00-01-01-
01-01-10 on VLAN 101:
Filter-mode
-----------
Active
Active
Active
IP address
---------------
10.1.1.10
10.1.1.11
deny-all
show ip verify source
MAC address
----------------- ---
00-01-01-01-01-01 100
00-01-01-01-01-10 101
deny-all
VLAN
791