Monitor Session Source Remote Vlan - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

monitor session source remote vlan

monitor session SESSION-NUMBER source remote vlan VLAN-ID
no monitor session SESSION-NUMBER source remote vlan
Syntax Description
SESSION-NUMBER
remote vlan VLAN-ID Specify the VLAN that the monitored source packets are tunneled over from the
Default
Command Mode
Usage Guideline
Example
CLI Reference Guide
Use the command to configure the RSPAN VLAN for a RSPAN destination
session. Use the no form of the command to remove configuration of the RSPAN
VLAN.
Specify the session number of the port mirroring session. The valid range is 1 to
80.
remote site. The valid range is 2 to 4094.
Not configured
Global configuration mode
Use the command on the destination switch of a RSPAN session.
The monitor session source remote vlan command configures the VLAN that the
monitored source packets are tunneled over from the remote site. Use the
monitor session destination interface command to configure the destination port.
Use the remote-span command in vlan config mode to specify a VLAN as a
RSPAN VLAN. When a VLAN is specified as a RSPAN VLAN, the access
member port of the VLAN except the destination interface will become inactive.
This example shows how to create a RSPAN session on the destination switch. It
assigns VLAN 100 as the RSPAN VLAN and eth1.4 as the destination port. It
also assigns VLAN 100 as the RSPAN VLAN. The monitored packets arrive at
port eth2.1 and will be transmitted out from port eth1.4.
monitor session source remote vlan
422