Spanning-Tree Mst Configuration - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

spanning-tree mst configuration

spanning-tree mst configuration
no spanning-tree mst configuration
Syntax
Default
Command Mode
Usage Guideline
.Examples
Switch(config)# spanning-tree mst configuration
Switch(config-mst)#
Switch(config)# no spanning-tree mst configuration
Switch(config)#
CLI Reference Guide
To enter MST-configuration submode, use the spanning-tree mst configuration
command. To return to the default settings, use the no form of this command.
None
The default value for the MST configuration is the default value for all its
parameters:
• No VLANs are mapped to any MST instance (all VLANs are mapped to
the CIST instance).
• The region name is the Bridge MAC Address.
Global configuration
The MST configuration consists of three main parameters:
• Instance VLAN mapping-See the instance command
• Region name-See the name (MST configuration submode) command
• Configuration revision number-See the revision command
The exit command is used to leave MST configuration submode.
Changing an MST-configuration submode parameter can cause connectivity
loss. To reduce service disruptions, when entering the MST-configuration
submode, make changes first to a copy of the current MST configuration before
applying them at the submode.
This example shows how to enter MST-configuration submode:
This example shows how to reset the MST configuration to the default settings:
spanning-tree mst configuration
850