Speed - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

speed

speed {10|100|1000[master|slave]|auto}
Syntax Description
10
100
1000
master
slave
auto
Default
Command Mode
Usage Guideline
CLI Reference Guide
Use this command to configure the physical port interface speed/duplex setting.
Specifies to set the port speed to transmit at 10 Mbps.
Specifies to set the port speed to transmit at 100 Mbps.
Specifies to set the port speed to transmit at 1000 Mbps.
• copper port: If the speed is set to 1000 Mbps, then the port must be
manually set as either a master or a slave port.
• fiber port (1000SX/LX): no-negotiation should be configured (i.e. auto-
negotiation disable).
(1000 only) Manually sets a copper port to be the master port.
(1000 only) Manually sets a copper port to be the slave port.
Specifies to determine the speed through auto-negotiation with its linked partner.
• copper port: Specify to determine the speed via auto-negotiation with its
linked partner.
• fiber port(1000SX/LX): auto-negotiation enable,auto-negotiation will be
started to negotiate the clock and flow control.
It will be auto for 100TX and 1000TX.
It will be fixed to 100 for 100FX.
It will be fixed to 1000 for 1000SX/LX.
Interface configuration
Only physical port interfaces are valid for this configuration.
If the specified speed is not supported by the hardware, error messages will be
returned.
1000SX/LX is always fixed to 1000 and full duplex.
100FX is always fixed 100 and full duplex.
For all SFP/XFP modules, duplex command will not take effect.
Auto-negotiation will be enabled whether the speed is set to auto or duplex is set
to auto. If the speed is set to auto, and duplex is set to fixed mode, then only the
speed will be negotiated. The advertised capability will be the configured duplex
mode combined with all possible speeds. If speed is to set to a fixed speed and
duplex is set to auto, then only duplex mode is negotiated. The advertised
speed
857