Show Cpu-Protect Type - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

show cpu-protect type

show cpu-protect type { PROTOCOL-NAME [UNIT-ID] | unit UNIT-ID }
Syntax Description
PROTOCOL-NAME
UNIT-ID]
[
UNIT-ID
unit
Default
Command Mode
Usage Guideline
Example
Switch# show cpu-protect type unit 1
Type
------------------ --------- --------- ---------
stp
gvrp
lacp
8021x
arp
icmpv4
icmpv6-neighbor
icmpv6-other
pim
rip
ospf
!--- Output suppressed.
Switch#
CLI Reference Guide
Use this command to show the rate-limit and statistics of CPU protection
The configured rate-limit and statistics of the specified protocol on CM-Card
and all existing IO-Cards will be displayed if the optional
specified. Otherwise, only the information on the specified unit id will be
displayed.
Specify the unit id which you want to display the rate-limit configuration and
statistics. For chassis system device, the unit ID is equal to blade ID (or slot
ID).
none
Privileged EXEC mode.
Show configured rate limit and drop-count of Safeguard engine of specific group.
These counters are counted by the software. There is probably deviation from
the hardware received if the packets are dropped before sent to CPU.
The following example is a sample output of show cpu-protect type command.
N/A means no rate-limit is applied to this protocol.
Pps Total
300 20
400 24
N/A 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Drop
0
0
0
0
0
0
0
0
0
0
0
show cpu-protect type
UNIT-ID] is not
[
572