D-Link DGS-6600-48T Cli Reference Manual page 542

DGS-6604 m
set
set { [ip] precedence PRECEDENCE | [ip] dscp DSCP | cos COS | internal-cos COS}
no set { [ip] precedence PRECEDENCE | [ip] dscp DSCP | cos COS | internal-cos COS}
Syntax Description
precedence
PRECEDENCE
dscp DSCP
cos COS
internal-cos COS
Default
Command Mode
Usage Guideline
Example
CLI Reference Guide
Use the set command in policy map class configuration mode to set the new
precedence field, DSCP field, and CoS field of the out-going packet. The user
can also directly specify the CoS queue for the packet.
Specifies a new precedence for the packet. The range is 0 to 7.
If the optional keyword ip is specified, then the IPv4 precedence will be marked.
Note that setting of precedence will not affect the CoS queue selection.
Specifies a new DSCP for the packet. The range is 0 to 63.
The optional keyword ip is specified, then the IPv4 DSCP will be marked.
Note that setting of DSCP will not affect the CoS queue selection.
Assigns a new cos value to the packet. The range is 0 to 7.
Note that setting of CoS will not affect the CoS queue selection.
Assigns the CoS queue to the packet. This overwrite the original CoS queue
selection.
Not configured
Policy-map class configuration
Use the set command to set the DSCP field, COS field, or precedence field of the
matched packet to a new value. Use set internal-cos command to directly assign
the CoS queue to the matched packet.
Configure multiple set commands for a class if they are not conflicting. For
example, precedence and dscp cannot be set at the same time.
The set dscp command will not affect the CoS queue selection. The set internal-
cos command will not alter the CoS field of the outgoing packet.
If the policer is applied as the policy for the traffic class, the set actions
configured by this command will be applied to the conforming packets. They will
not be applied to the exceeding packet and the violating packet.
In the following example, the policy map policy1 is configured with the policy for
the class1 class. The packets that are included in the class1 class will be set to a
set
532