Revision - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

revision

revision REVISION
no revision
Syntax Description
REVISION
Default
Command Mode
Usage Guideline
Example
Swtich(config)# spanning-tree mst configuration
Switch(config-mst)#revision 2
CLI Reference Guide
To set the revision number for the MST configuration, use the revision command.
To return to the default settings, use the no form of this command.
When a switch using the same given name but with a different revision level than
another switch, then the two switches are considered members of different MST
regions. The range is 0 to 65535.
REVISION: 0
MST configuration
If Two DGS-6604 series Ethernet switches have the same configuration but with
different revision numbers, then they are considered to be part of two different
regions.
Be careful when using the revision command to set the revision
Caution:
number of the MST configuration because a mistake can put the switch in a
different region.
This example shows how to configure the revision level of MSTP configuration to
2.
Verify the settings by entering the show spanning-tree mst configuration
command.
revision
513