Ipv6 Rip Metric-Offset - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604

ipv6 rip metric-offset

ipv6 rip metric-offset METRIC-VALUE
no ipv6 rip metric-offset
Syntax Description
METRIC-VALUE
Default
Command Mode
Usage Guideline
Example
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 rip metric-offset 10
CLI Reference Guide
To set the IPv6 RIP metric for an interface, use the ipv6 rip metric-offset
command. To return the metric to its default value, use the no form of this
command.
Value added to the metric of an IPv6 RIP route received in a report message. A
number from 1 to 16.
The default metric value is 1.
Interface configuration
When an IPv6 RIP route is received, the interface metric value set by the ipv6 rip
metric-offset command is added before the route is inserted into the routing
table. Increasing the IPv6 RIP metric value of an interface will increase the metric
value of IPv6 RIP routes received over the interface.
Use the ipv6 rip metric-offset command to influence which routes are used.
The IPv6 RIP metric is in the hop count.
The following example configures a metric increment of 10 for the RIP routing
process.
ipv6 rip metric-offset
348