D-Link DGS-6600-48T Cli Reference Manual page 481

DGS-6604 m
Example
Switch(config)# interface range eth3.1-3.5
Switch(config-if-range)# poe power-inline auto
Switch(config)# interface eth3.1
Switch(config-if)# poe power-inline static max 7000
Switch(config)# interface eth3.1
Switch(config-if)# poe power-inline never
Switch(config)# interface eth3.1
Switch(config-if)# poe power-inline auto time-range rd_time
CLI Reference Guide
IEEE802.3af, it will be 16.9785W. This design is also for the better conformance
of DGS-6600's PoE functionality. But we strongly recommend using 15.4W as
the maximum power threshold in static mode. If PD only needs 15.4W, but the
port is configured as maximum power threshold. That means PoE system will
take 17W from system power budget and 1.6W will be wasted!
The time range function could be also applied on PoE with a per-port based
methodology. Once a PoE port is combined with a time-range profile, it will only
be activated with the time range which that profile specified. The time-range
profile must be created before it is applied.
This example shows how to enable detection of a powered device and to
automatically power a PoE port for interface eth3.1-3.5.
The following is an example showing how to configure a PoE interface eth3.1,
allows class 1 or a class 2 powered device under 7000mw:
This example shows how to disable powered-device detection and to not power
a PoE port (eth3.1).
This example shows how to combine a time-range profile "rd_time" with PoE
interface eth3.1.
You can verify your settings by entering the poe power inline status command.
471