Set Ipv6 Default Next-Hop - D-Link DGS-6600-48T Cli Reference Manual

DGS-6604 m

set ipv6 default next-hop

set ipv6 default next-hop IPv6-ADDRESS
no set ipv6 default next-hop [IPv6-ADDRESS]
Syntax Description
IPv6-ADDRESS
Default
Command Mode
Usage
Guideline
Examples
CLI Reference Guide
Use the command in route-map configuration mode to set the next hop to route the packets
that pass a match clause of a route map and there is no route for the packets. To remove the
setting, use the no form of the command to remove the setting.
Specify the next hop to route the packet. The next hop must be an adjacent router.
Not configured
Route-map configuration
You can use this command to set the next hop to route the packets that pass a
match clause of a route map.
If other set clauses for policy based routing are used with the command, they will be evaluated
based on the following ordering:
1. set ipv6 next-hop
2. set interface
3. set ipv6 default next-hop
4. set default interface
With this ordering, the set interface clauses and the set interface clauses will be evaluated
before look up of the routing table. If route cannot be found for the packets, the set ip default
next-hop and set default interface command will be evaluated.
In the following example, PBR will change the next-hop setting when the source ip is
2000::/16 and vlan is vlan100 and can not found the destination address in routing table.
We want to set next-hop of this route entry to 100::BEAE:C5FF:FE9A . The steps as fol-
lows:
At first, create an IP basic access list, named Strict-Control which permit prefix 2000::/16
Secondly, create a route map, named myPolicy which define a match rule to associate ip
address prefix-list to the previously created access list, Strict-Control.
Lastly, in Vlan Interface configuration mode set the conditionally redistributed to previously
created route-map, myPolicy.
set ipv6 default next-hop
542